Quick tip: Distribution Point Configuration Status not fully successful

dp-status-01Last week a customer asked me why the Completion Statistics some of his Distribution Points in the Distribution Point Configuration Status node were not all successful and why one package was still stated as In Progress since early February of this year (like shown in the figure on the left). An easy answer for this question if you ask me.

What happened was that while a package was distributed to remote distribution points, and before the package was finished distributing the package was deleted from Configuration Manager 2012 R2. So the status was still shown In Progress for some of the Distribution Points with slower bandwidths.


The solution to fix this was easy, since the content was not available anymore. What must be done is enable and configure Content Validation on your Distribution Point(s). Content Validation verifies the integrity of the packages on the distribution points.

Enable the Content Validation on the DP
Enable the Content Validation on the DP

After that the Content Validation had done his work the Distribution Point Configuration Status of all distribution points were successful.

All good! :)
All good! 🙂

Enjoy & till next time!


Leave a Reply

Your email address will not be published. Required fields are marked *

Previous Post

Enabling Remote Administration on a Mac OS X device with Compliance Settings

Next Post

Cumulative Update 2 for System Center 2012 R2 Configuration Manager released

Related Posts